Proximal fixation anterior to the lateral femoral epicondyle optimizes isometry in anterolateral ligament reconstruction.

Concomitant anterolateral ligament (ALL) injury is often observed in patients with an anterior cruciate ligament injury leading some to recommend concurrent ALL reconstruction. In ligament reconstruction, it is imperative to restore desirable ligament length changes to prevent stress on the graft. The purpose of this investigation is to identify the optimal femoral and tibial locations for fixation in ALL reconstruction. 3D computerized tomography (CT) knee models were obtained from six fresh-frozen, unpaired, cadaveric human knees at 0°, 10°, 20°, 30°, 40°, 90°, 110°, and 125°of knee flexion. Planar grids were projected onto the lateral knee. Isometry between each tibial and femoral grid point was calculated at each angle of flexion by the length change in reference to the length at 0° of knee flexion. The mean normalized length change over the range of motion was calculated for each combination of points at all angles of flexion were calculated. Fixation of the ALL to the lateral femoral epicondyle or 5 mm anterior to the epicondyle with tibial fixation on the posteroinferior aspect of the tibial condyle (14-21 mm posterior to Gerdy's tubercle and 13-20 mm below the joint line) provided the lowest average length change for all possible ALL tibial insertion points. Minimal length change for all femoral fixation locations occurred from 20° to 40° of flexion, which identifies the angle of flexion where graft tensioning should occur intraoperatively. With the use of 3D reconstructed models of knee-CT scans, we observed that there was no ALL fixation point that was truly isometric throughout range of motion. Fixation of the anterolateral ligament on the lateral femoral epicondyle or anterior to the lateral femoral epicondyle and on the inferoposterior aspect of the tibial condyle restores isometry. Additionally, minimal length change was observed between 20° and 40° of flexion, which is the most appropriate range of knee flexion to tension the graft. Reproducing isometry reduces stress on the graft, which minimizes the risk of graft failure.