Evaluation of the effect of laboratory methods on semen analysis and breeding soundness examination (BSE) classification in stallions.


Journal

Theriogenology
ISSN: 1879-3231
Titre abrégé: Theriogenology
Pays: United States
ID NLM: 0421510

Informations de publication

Date de publication:
15 Jan 2020
Historique:
received: 02 03 2019
revised: 09 08 2019
accepted: 21 09 2019
pubmed: 4 10 2019
medline: 4 8 2020
entrez: 4 10 2019
Statut: ppublish

Résumé

The stallion Breeding Soundness Examination (BSE), as proposed by the Society for Theriogenology, recommends that a stallion produce a minimum of one billion progressively motile, morphologically normal sperm (PMMNS) in the second of two ejaculates collected 1 h apart to be classified as a Satisfactory Prospective Breeder. With this in mind, the first objective of this study was to determine if the classification outcome of the traditional BSE differs depending on the methods used to evaluate sperm motility, morphology and concentration. We hypothesized that application of Computer Assisted Sperm Motion Analysis (CASA) and Differential Interference Contrast (DIC) microscopy to stallion semen evaluation would yield a more conservative estimate of the number of PMMNS. If this hypothesis is correct, then the use of CASA and DIC microscopy for semen evaluation would result in significantly fewer stallions meeting the historical standards for classification as a Satisfactory Prospective Breeder. Additionally, we determined whether the use of these modern technologies resulted in more accurate prediction of the actual fertility of a stallion compared to the use of more traditional technologies. Our results support the hypothesis that modern semen analysis techniques (including CASA and DIC microscopy) result in more conservative estimates of the number of PMMNS when compared to standard semen analysis techniques. As a result, the choice of methods used for semen analysis may impact the outcome of the traditional BSE. However, none of the methodologies used in this study reliably predicted different levels of fertility among this group of moderately to highly fertile stallions within the context of the traditional BSE. Additionally, the only individual semen measure that was significantly correlated with fertility was the percentage of morphologically normal sperm as determined using DIC microscopy. These results caution against strict use of the traditional 'cutoff' of 1 billion PMMNS for classification of breeding potential, particularly when attempting to differentiate between moderately and highly fertile stallions and regardless of the laboratory methods employed for semen analysis.

Identifiants

pubmed: 31581045
pii: S0093-691X(19)30427-3
doi: 10.1016/j.theriogenology.2019.09.035
pii:
doi:

Types de publication

Journal Article

Langues

eng

Sous-ensembles de citation

IM

Pagination

67-76

Informations de copyright

Copyright © 2019 Elsevier Inc. All rights reserved.

Auteurs

Kristina Whitesell (K)

Department of Clinical Studies, New Bolton Center, University of Pennsylvania, School of Veterinary Medicine, 382 W. Street Rd., Kennett Square, PA, 19348, USA.

Darko Stefanovski (D)

Department of Clinical Studies, New Bolton Center, University of Pennsylvania, School of Veterinary Medicine, 382 W. Street Rd., Kennett Square, PA, 19348, USA.

Sue McDonnell (S)

Department of Clinical Studies, New Bolton Center, University of Pennsylvania, School of Veterinary Medicine, 382 W. Street Rd., Kennett Square, PA, 19348, USA.

Regina Turner (R)

Department of Clinical Studies, New Bolton Center, University of Pennsylvania, School of Veterinary Medicine, 382 W. Street Rd., Kennett Square, PA, 19348, USA. Electronic address: rmturner@vet.upenn.edu.

Articles similaires

Smoking Cessation and Incident Cardiovascular Disease.

Jun Hwan Cho, Seung Yong Shin, Hoseob Kim et al.
1.00
Humans Male Smoking Cessation Cardiovascular Diseases Female
Humans United States Aged Cross-Sectional Studies Medicare Part C
1.00
Humans Yoga Low Back Pain Female Male
Humans Meals Time Factors Female Adult

Classifications MeSH