Patient-specific rods for thoracic kyphosis correction in adolescent idiopathic scoliosis surgery: Preliminary results.


Journal

Orthopaedics & traumatology, surgery & research : OTSR
ISSN: 1877-0568
Titre abrégé: Orthop Traumatol Surg Res
Pays: France
ID NLM: 101494830

Informations de publication

Date de publication:
Feb 2020
Historique:
received: 30 10 2018
revised: 02 07 2019
accepted: 22 07 2019
pubmed: 24 11 2019
medline: 25 6 2021
entrez: 24 11 2019
Statut: ppublish

Résumé

Restoring a degree of kyphosis consistent with good sagittal alignment of the spine is a key concern when performing surgery to correct adolescent idiopathic scoliosis (AIS). The objective of this study was to assess the preliminary outcomes of posterior fusion for AIS using patient-specific rods that were pre-contoured based on pelvic incidence. The primary evaluation criterion was thoracic kyphosis at last follow-up. The use of pre-bent patient-specific rods has a favourable effect on thoracic kyphosis at last follow-up. A total of 37 patients with AIS, including 17 with hypokyphosis, managed with patient-specific rods were included in a prospective study. The rod contouring angles were based on predefined pelvic incidence criteria (25° to 40° for the rod on the convex side and the same value plus 10° for the rod on the concave side). Thoracic kyphosis was assessed before surgery and at last follow-up, after 12-36 months (mean, 19 months). Student's t test was applied to compare means. Multivariate linear regression analysis was performed. At last follow-up, the mean increase in kyphosis was 14° and was comparable to the planned increase (mean difference=0, p=0.85). Factors associated with kyphosis at last follow-up were the concave rod contouring angle and the pre-operative kyphotic angle of the thoracic segment to be instrumented (p<0.05). Mean differences between kyphosis of the instrumented thoracic segment at last follow-up and target kyphosis were -5° in the subgroup with hypokyphosis (<20°) before surgery and +4° in the subgroup with normal kyphosis before surgery. With patient-specific rods, kyphosis at last follow-up was close to the target value. Predictors of kyphosis at last follow-up were the concave rod contouring angle and pre-operative kyphotic angle of the thoracic segment to be instrumented. Over-contouring of the concave rod seems necessary in patients with preoperative hypokyphosis but not in patients with normal kyphosis. III, prospective non-comparative study.

Identifiants

pubmed: 31757655
pii: S1877-0568(19)30349-4
doi: 10.1016/j.otsr.2019.07.027
pii:
doi:

Types de publication

Journal Article

Langues

eng

Sous-ensembles de citation

IM

Pagination

159-165

Informations de copyright

Copyright © 2019 Elsevier Masson SAS. All rights reserved.

Auteurs

Federico Solla (F)

Orthopédie Pédiatrique, hôpital Pédiatrique de Nice CHU-Lenval, 57, avenue Californie, 06200 Nice, France. Electronic address: fedesolla@hotmail.com.

Jean-Luc Clément (JL)

Orthopédie Pédiatrique, hôpital Pédiatrique de Nice CHU-Lenval, 57, avenue Californie, 06200 Nice, France.

Vincent Cunin (V)

Orthopédie Pédiatrique, CHU de Lyon, 69800 Bron, France.

Carlo M Bertoncelli (CM)

Orthopédie Pédiatrique, hôpital Pédiatrique de Nice CHU-Lenval, 57, avenue Californie, 06200 Nice, France.

Vincent Fière (V)

Chirurgie du rachis, centre orthopédique Santy et HPJM Lyon GDS Ramsay, Lyon, France.

Virginie Rampal (V)

Orthopédie Pédiatrique, hôpital Pédiatrique de Nice CHU-Lenval, 57, avenue Californie, 06200 Nice, France.

Articles similaires

[Redispensing of expensive oral anticancer medicines: a practical application].

Lisanne N van Merendonk, Kübra Akgöl, Bastiaan Nuijen
1.00
Humans Antineoplastic Agents Administration, Oral Drug Costs Counterfeit Drugs

Smoking Cessation and Incident Cardiovascular Disease.

Jun Hwan Cho, Seung Yong Shin, Hoseob Kim et al.
1.00
Humans Male Smoking Cessation Cardiovascular Diseases Female
Humans United States Aged Cross-Sectional Studies Medicare Part C
1.00
Humans Yoga Low Back Pain Female Male

Classifications MeSH