Testing the impact of discoplasty on the biomechanics of the intervertebral disc with simulated degeneration: An in vitro study.
Biomechanical testing
Percutaneous cement discoplasty
Spine
Strain
Journal
Medical engineering & physics
ISSN: 1873-4030
Titre abrégé: Med Eng Phys
Pays: England
ID NLM: 9422753
Informations de publication
Date de publication:
10 2020
10 2020
Historique:
received:
19
03
2020
revised:
21
07
2020
accepted:
26
07
2020
entrez:
26
9
2020
pubmed:
27
9
2020
medline:
19
8
2021
Statut:
ppublish
Résumé
Percutaneous Cement Discoplasty has recently been developed to relieve pain in highly degenerated intervertebral discs presenting a vacuum phenomenon in patients that cannot undergo major surgery. Little is currently known about the biomechanical effects of discoplasty. This study aimed at investigating the feasibility of modelling empty discs and subsequent discoplasty surgery and measuring their impact over the specimen geometry and mechanical behaviour. Ten porcine lumbar spine segments were tested in flexion, extension, and lateral bending under 5.4 Nm (with a 200 N compressive force and a 27 mm offset). Tests were performed in three conditions for each specimen: with intact disc, after nucleotomy and after discoplasty. A 3D Digital Image Correlation (DIC) system was used to measure the surface displacements and strains. The posterior disc height, range of motion (ROM), and stiffness were measured at the peak load. CT scans were performed to confirm that the cement distribution was acceptable. Discoplasty recovered the height loss caused by nucleotomy (p = 0.04) with respect to the intact condition, but it did not impact significantly either the ROM or the stiffness. The strains over the disc surface increased after nucleotomy, while discoplasty concentrated the strains on the endplates. In conclusion, this preliminary study has shown that discoplasty recovered the intervertebral posterior height, opening the neuroforamen as clinically observed, but it did not influence the spine mobility or stiffness. This study confirms that this in vitro approach can be used to investigate discoplasty.
Identifiants
pubmed: 32977922
pii: S1350-4533(20)30122-3
doi: 10.1016/j.medengphy.2020.07.024
pii:
doi:
Types de publication
Journal Article
Research Support, Non-U.S. Gov't
Langues
eng
Sous-ensembles de citation
IM
Pagination
51-59Informations de copyright
Copyright © 2020. Published by Elsevier Ltd.
Déclaration de conflit d'intérêts
Declaration of Competing Interest There is no potential conflict of interest: none of the Authors received or will receive direct or indirect benefits from third parties for the performance of this study.