Impact of incorporated drugs on material properties of amorphous solid dispersions.


Journal

European journal of pharmaceutics and biopharmaceutics : official journal of Arbeitsgemeinschaft fur Pharmazeutische Verfahrenstechnik e.V
ISSN: 1873-3441
Titre abrégé: Eur J Pharm Biopharm
Pays: Netherlands
ID NLM: 9109778

Informations de publication

Date de publication:
Feb 2021
Historique:
received: 23 10 2020
revised: 19 12 2020
accepted: 21 12 2020
pubmed: 1 1 2021
medline: 28 9 2021
entrez: 31 12 2020
Statut: ppublish

Résumé

Formulation development of amorphous solid dispersions (ASD) still is challenging although several poorly water-soluble drugs have been marketed using this technique. During development of novel drugs, the selection of the preparation technique and polymer matrix is commonly performed for the certain drug via screening tools. However, if general trends regarding material properties are to be investigated, this approach is not beneficial, although often utilized in literature. The main component of the ASD usually is the polymer and thus it predominantly determines the material properties of the system. Therefore, to study the impact of different drugs and their drug loads on mechanical properties and wettability, three poorly soluble model drugs with drug loads ranging from 10% to 40% were incorporated into copovidone via hot-melt extrusion. The obtained extrudates were subsequently characterized regarding mechanical properties by applying diametral compression test and nanoindentation and the results were compared to the performance during tablet compression. Incorporation of all tested drugs resulted in a similar increase in brittleness of the ASDs, whereas the Young's modulus and hardness changed differently in dependence of the incorporated drug. These observations correlated well with the performance during tablet compression and it was concluded, that the brittleness seemed to be the predominant factor influencing the compression behavior of copovidone-based ASDs. Furthermore, the degree of water absorption and wettability was assessed by applying dynamic vapor sorption experiments and contact angle measurements. Here, the incorporated drugs impacted the contact angle to different degrees and a strong correlation between the contact angle and disintegration time was observable. These results highlight the importance of thorough characterization of the ASDs as it helps to predict their performance during tablet compression and thus facilitates the optimal selection of excipients.

Identifiants

pubmed: 33383170
pii: S0939-6411(20)30377-5
doi: 10.1016/j.ejpb.2020.12.017
pii:
doi:

Substances chimiques

Excipients 0
Polymers 0
Solvents 0
Tablets 0
Water 059QF0KO0R

Types de publication

Journal Article

Langues

eng

Sous-ensembles de citation

IM

Pagination

88-98

Informations de copyright

Copyright © 2020 Elsevier B.V. All rights reserved.

Auteurs

Karsten Flügel (K)

Faculty of Biochemical and Chemical Engineering, Laboratory of Solids Process Engineering, Technical University Dortmund, Emil-Figge-Str. 68, 44227 Dortmund, Germany; Department of Pharmaceutical Technologies, Merck KGaA, Frankfurter Str. 250, 64293 Darmstadt, Germany.

Katharina Schmidt (K)

Department of Pharmaceutical Technologies, Merck KGaA, Frankfurter Str. 250, 64293 Darmstadt, Germany.

Lena Mareczek (L)

Department of Pharmaceutical Technologies, Merck KGaA, Frankfurter Str. 250, 64293 Darmstadt, Germany.

Michael Gäbe (M)

Department of Pharmaceutical Technologies, Merck KGaA, Frankfurter Str. 250, 64293 Darmstadt, Germany.

Robert Hennig (R)

Department of Pharmaceutical Technologies, Merck KGaA, Frankfurter Str. 250, 64293 Darmstadt, Germany.

Markus Thommes (M)

Faculty of Biochemical and Chemical Engineering, Laboratory of Solids Process Engineering, Technical University Dortmund, Emil-Figge-Str. 68, 44227 Dortmund, Germany. Electronic address: professors.fsv.bci@tu-dortmund.de.

Articles similaires

Animals Dietary Fiber Dextran Sulfate Mice Disease Models, Animal
Vancomycin Polyesters Anti-Bacterial Agents Models, Theoretical Drug Liberation
Semiconductors Photosynthesis Polymers Carbon Dioxide Bacteria
Silicon Dioxide Water Hot Temperature Compressive Strength X-Ray Diffraction

Classifications MeSH