The effect of vertebral level on biomechanical properties of the lumbar paraspinal muscles in a rat model.
Biomechanics
Collagen
Muscle
Passive stiffness
Slack sarcomere length
Spine
Journal
Journal of the mechanical behavior of biomedical materials
ISSN: 1878-0180
Titre abrégé: J Mech Behav Biomed Mater
Pays: Netherlands
ID NLM: 101322406
Informations de publication
Date de publication:
06 2021
06 2021
Historique:
received:
16
09
2020
revised:
07
02
2021
accepted:
04
03
2021
pubmed:
30
3
2021
medline:
20
5
2021
entrez:
29
3
2021
Statut:
ppublish
Résumé
Passive mechanical properties of the paraspinal muscles are important to the biomechanical functioning of the spine. In most computational models, the same biomechanical properties are assumed for each paraspinal muscle group, while cross-sectional area or fatty infiltration in these muscles have been reported to differ between the vertebral levels. Two important properties for musculoskeletal modeling are the slack sarcomere length and the tangent modulus. This study aimed to investigate the effect of vertebral level on these biomechanical properties of paraspinal muscles in a rat model. The left paraspinal muscles of 13 Sprague-Dawley rats were exposed under anesthesia. Six muscle biopsies were collected from each rat: three from multifidus (one per each of the L1, L3, and L5 levels) and similarly three from longissimus. Each biopsy was cut into two halves. From one half, two to three single muscle fibers and two to six muscle fiber bundles (14 ± 7 fibers surrounded in their connective tissue) were extracted and mechanically tested in a passive state. From the resulting stress-strain data, tangent modulus was calculated as the slope of the tangent at 30% strain and slack sarcomere length (beyond which passive force starts to develop) was recorded. The other half of each biopsy, which represented the muscle at the fascicle level, was snap frozen, sectioned, stained for Collagen I and its area fraction was measured. To evaluate the effect of spinal level on these biomechanical properties of multifidus and longissimus, one-way repeated measures ANOVA (p < 0.05) was performed for tangent modulus and slack sarcomere length, while for collagen I content linear mixed-models analysis was adopted. In total, 192 fibers and 262 fiber bundles were mechanically tested. For both muscle groups, no significant difference in tangent modulus of the single fibers was detected between the three spinal levels (p = 0.9 for multifidus and p = 0.08 for longissimus). Similarly, the tangent modulus values for the fiber bundles were not significantly different between the three spinal levels (p = 0.13 for multifidus and p = 0.49 for longissimus). In both muscle groups, the slack sarcomere lengths were not different among the spinal levels except for multifidus fibers (p = 0.02). Collagen I area fraction in muscle fascicles averaged 6.8% for multifidus and 5.3% for longissimus and was not different between the spinal levels. The results of this study highlighted that the tangent modulus, slack sarcomere length, and collagen I content of the lumbar paraspinal muscles are independent of spinal level. This finding provides the basis for the assumption of similar mechanical properties along a paraspinal muscle group.
Identifiants
pubmed: 33780860
pii: S1751-6161(21)00133-8
doi: 10.1016/j.jmbbm.2021.104446
pii:
doi:
Types de publication
Journal Article
Research Support, Non-U.S. Gov't
Langues
eng
Sous-ensembles de citation
IM
Pagination
104446Informations de copyright
Copyright © 2021 Elsevier Ltd. All rights reserved.