Study the fuel characteristics of ethanol and waste engine oil pyrolytic oil blends.
Alcohol
Blending
Gasoline
Higher heating value
Pyrolysis
Waste oil
Journal
Environmental science and pollution research international
ISSN: 1614-7499
Titre abrégé: Environ Sci Pollut Res Int
Pays: Germany
ID NLM: 9441769
Informations de publication
Date de publication:
Jul 2022
Jul 2022
Historique:
received:
12
03
2021
accepted:
29
06
2021
pubmed:
17
7
2021
medline:
20
7
2022
entrez:
16
7
2021
Statut:
ppublish
Résumé
This study shows the application of pyrolytic oil derived from waste engine oil (WEOPO) as an alternative fuel by blending with ethanol. For this, the effect of blending of ethanol at 5 %, 10 %, 15 %, 20 %, 25 %, and 30 % on the compositions and fuel properties were analyzed. The utmost blending was established based on the higher heating value. The pyrolytic oil used for this study was produced at 550 °C which was the optimum pyrolytic temperature. A comparison study of the blended oil was performed with commercially available gasoline to observe the similarities in their fuel properties and composition. The study confirmed that ethanol can be blended with WEOPO at 20 % by volume to obtain a fuel of a higher heating value of about 44.24 MJ/kg that can be used as fuel. Since WEOPO contains 65.80 % of C4-C12 (gasoline range), hydrocarbon compounds and the rest 31.48 % C11-C15, 11.84 % C15-C19, and 6.94 % > C19 compounds, it can be used as a future fuel.
Identifiants
pubmed: 34268693
doi: 10.1007/s11356-021-15281-8
pii: 10.1007/s11356-021-15281-8
doi:
Substances chimiques
Gasoline
0
Vehicle Emissions
0
Ethanol
3K9958V90M
Types de publication
Journal Article
Langues
eng
Sous-ensembles de citation
IM
Pagination
50928-50936Informations de copyright
© 2021. The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature.
Références
Abu ER, Ossman ME, Farouq R, Abd-Elfatah M (2015) Used motor oil treatment: turning waste oil into valuable products. IJCBS 7:757–767
Arpa O, Yumrutas R (2010) Experimental investigation of gasoline-like fuel obtained from waste lubrication oil on engine performance and exhaust emission. Fuel Process Technol 91:197–204. https://doi.org/10.1016/j.fuproc.2009.09.018
doi: 10.1016/j.fuproc.2009.09.018
Arpa O, Yumrutaş R, Argunhan Z (2010a) Experimental investigation of the effects of diesel-like fuel obtained from waste lubrication oil on engine performance and exhaust emission. Fuel Process Technol 91:1241–1249. https://doi.org/10.1016/j.fuproc.2010.04.004
doi: 10.1016/j.fuproc.2010.04.004
Arpa O, Yumrutas R, Demirbas A (2010b) Production of diesel-like fuel from waste engine oil by pyrolitic distillation. Appl Energy 87:122–127. https://doi.org/10.1016/j.apenergy.2009.05.042
Basu P (2018) Biomass gasification, pyrolysis and torrefaction: practical design and theory. Academic Press
Batov AE, Kadiev KM, Kadieva MK, et al (2018) hydrogenation processing of heavy oil wastes in the presence of highly efficient ultrafine catalysts. In: Proceedings of the Scientific-Practical Conference “Research and Development - 2016.” Springer International Publishing, pp 659–667
Bert BV, Holle E, Florijn J (2018) The use of a fast pyrolysis oil – Ethanol blend in diesel engines for chp applications. Biomass Bioenerg. 110:114-122. https://doi.org/10.1016/j.biombioe.2018.01.023
Chang F-C, Tsai M-J, Ko C-H (2018) Agricultural waste derived fuel from oil meal and waste cooking oil. Environ Sci Pollut Res Int 25:5223–5230. https://doi.org/10.1007/s11356-017-9119-x
doi: 10.1007/s11356-017-9119-x
Demirbas A, Baluabaid MA, Kabli M, Ahmad W (2015) Diesel fuel from waste lubricating oil by pyrolitic distillation. Pet Sci Technol 33:129–138. https://doi.org/10.1080/10916466.2014.955921
doi: 10.1080/10916466.2014.955921
Dong J, Tang Y, Nzihou A, Chi Y, Weiss-Hortala E, Ni M (2018) Life cycle assessment of pyrolysis, gasification and incineration waste-to-energy technologies: theoretical analysis and case study of commercial plants. Sci Total Environ 626:744–753. https://doi.org/10.1016/j.scitotenv.2018.01.151
doi: 10.1016/j.scitotenv.2018.01.151
Foschi E, D’Addato F, Bonoli A (2021) Plastic waste management: a comprehensive analysis of the current status to set up an after-use plastic strategy in Emilia-Romagna Region (Italy). Environ Sci Pollut Res Int 28:24328–24341. https://doi.org/10.1007/s11356-020-08155-y
doi: 10.1007/s11356-020-08155-y
Fuentes MJ, Font R, Gómez-Rico MF, Martín-Gullón I (2007) Pyrolysis and combustion of waste lubricant oil from diesel cars: decomposition and pollutants. J Anal Appl Pyrolysis 79:215–226. https://doi.org/10.1016/j.jaap.2006.12.004
doi: 10.1016/j.jaap.2006.12.004
Gadwal SB, Banapurmath NR, Kamoji MA, Rampure PB, Khandal SV (2019) Performance and emission characteristic studies on CRDI diesel engine fuelled with plastic pyrolysis oil blended with ethanol and diesel. Int J Sustainable ConstrEngTechnol 12:262–271. https://doi.org/10.1080/19397038.2018.1527863
doi: 10.1080/19397038.2018.1527863
Kareddula VK, Puli RK (2018) Influence of plastic oil with ethanol gasoline blending on multi cylinder spark ignition engine. Alex Eng J 57:2585–2589. https://doi.org/10.1016/j.aej.2017.07.015
doi: 10.1016/j.aej.2017.07.015
Kim SS, Kim SH (2000) Pyrolysis kinetics of waste automobile lubricating oil. Fuel 79:1943–1949. https://doi.org/10.1016/S0016-2361(00)00028-4
doi: 10.1016/S0016-2361(00)00028-4
Kumar N, Sidharth (2018) Some Studies on use of ternary blends of diesel, biodiesel and n-octanol. Energy Sources Part A 40:1721–1728. https://doi.org/10.1080/15567036.2018.1486902
doi: 10.1080/15567036.2018.1486902
Kumar S, Prakash R, Murugan S, Singh RK (2013) Performance and emission analysis of blends of waste plastic oil obtained by catalytic pyrolysis of waste HDPE with diesel in a CI engine. Energy Convers Manag 74:323–331. https://doi.org/10.1016/j.enconman.2013.05.028
doi: 10.1016/j.enconman.2013.05.028
Lam SS, Russell AD, Chase HA (2010) Microwave pyrolysis, a novel process for recycling waste automotive engine oil. Energy 35:2985–2991. https://doi.org/10.1016/j.energy.2010.03.033
doi: 10.1016/j.energy.2010.03.033
Lam SS, Russell AD, Lee CL, Chase HA (2012) Microwave-heated pyrolysis of waste automotive engine oil: Influence of operation parameters on the yield, composition, and fuel properties of pyrolysis oil. Fuel 92:327–339. https://doi.org/10.1016/j.fuel.2011.07.027
doi: 10.1016/j.fuel.2011.07.027
Lee S, Kim TY (2015) Feasibility study of using wood pyrolysis oil–ethanol blended fuel with diesel pilot injection in a diesel engine. Fuel 162:65–73. https://doi.org/10.1016/j.fuel.2015.08.049
doi: 10.1016/j.fuel.2015.08.049
Martin JA, Boateng AA (2014) Combustion performance of pyrolysis oil/ethanol blends in a residential-scale oil-fired boiler. Fuel 133:34–44. https://doi.org/10.1016/j.fuel.2014.05.005
doi: 10.1016/j.fuel.2014.05.005
Osman DI, Attia SK, Taman AR (2018) Recycling of used engine oil by different solvent. Egypt J Pet 27:221–225. https://doi.org/10.1016/j.ejpe.2017.05.010
doi: 10.1016/j.ejpe.2017.05.010
Pali HS, Kumar N (2016) Comparative assessment of sal and kusum biodiesel properties. Energy Sources Part A 38:3391–3396. https://doi.org/10.1080/15567036.2015.1136974
doi: 10.1080/15567036.2015.1136974
Patel MHM, Patel TM (2012) Performance analysis of single cylinder diesel engine fuelled with pyrolysis oil-diesel and its blend with Ethanol. International Journal of Engineering Research and Technology 1:
Patel N, Shadangi KP (2020a) Thermochemical conversion of waste engine oil (WEO) to gasoline-rich crude oil. J Mater Cycles Waste Manage 22:536–546. https://doi.org/10.1007/s10163-019-00948-9
doi: 10.1007/s10163-019-00948-9
Patel N, Shadangi KP (2020b) Characterization of waste engine oil (WEO) pyrolytic oil and diesel blended oil: fuel properties and compositional analysis. Materials Today: Proceedings 33:4933–4936. https://doi.org/10.1016/j.matpr.2020.02.679
doi: 10.1016/j.matpr.2020.02.679
Patel N, Shadangi KP, Kar PK (2021) Characterization of waste engine oil derived pyrolytic char (WEOPC): SEM, EDX and FTIR analysis. Materials Today: Proceedings 38:2866–2870. https://doi.org/10.1016/j.matpr.2020.09.138
Rao GLN, Sampath S, Rajagopal K (2008) Experimental studies on the combustion and emission characteristics of a diesel engine fuelled with used cooking oil methyl esterand its diesel blends. Int J Mech Mechatron Eng 2(1):90–96. https://doi.org/10.5281/zenodo.1061368
Sarkar A, Langanki M, Chowdhury R (2014) Studies on pyrolysis of spent engine oil in a quartz load cell. Int J Eng Res Technol 3(6):222-226. https://doi.org/10.15623/ijret.2014.0306041
Sathe SS, Mahanta C, Mishra P (2018) Simultaneous influence of indigenous microorganism along with abiotic factors controlling arsenic mobilization in Brahmaputra floodplain, India. J Contam Hydrol 213:1–14. https://doi.org/10.1016/j.jconhyd.2018.03.005
doi: 10.1016/j.jconhyd.2018.03.005
Sonthalia A, Kumar N (2021) Comparison of fuel characteristics of hydrotreated waste cooking oil with its biodiesel and fossil diesel. Environ Sci Pollut Res Int 28:11824–11834. https://doi.org/10.1007/s11356-019-07110-w
doi: 10.1007/s11356-019-07110-w
Teng ST, Williams AD, Urdal K (1994) Detailed hydrocarbon analysis of gasoline by GC-MS (SI-PIONA). J High Resolut Chromatogr 17:469–475. https://doi.org/10.1002/jhrc.1240170614
doi: 10.1002/jhrc.1240170614
Tripathi AK, Ojha DK, Vinu R (2015) Selective production of valuable hydrocarbons from waste motorbike engine oils via catalytic fast pyrolysis using zeolites. J Anal Appl Pyrolysis 114:281–292. https://doi.org/10.1016/j.jaap.2015.06.009
doi: 10.1016/j.jaap.2015.06.009