Effect of single tube sections on the structural safety of Chinese solar greenhouse skeletons.
Journal
Scientific reports
ISSN: 2045-2322
Titre abrégé: Sci Rep
Pays: England
ID NLM: 101563288
Informations de publication
Date de publication:
29 09 2021
29 09 2021
Historique:
received:
22
12
2020
accepted:
08
09
2021
entrez:
30
9
2021
pubmed:
1
10
2021
medline:
1
10
2021
Statut:
epublish
Résumé
In recent years, the use of single-tube skeletons for the construction of Chinese solar greenhouses has increased. As a consequence, during the selection of the construction materials, the safety of these structures has become an important issue. The single tube section has various forms, but there is no scientific theory to guide the selection process. To the best of our knowledge, the scientific analysis of the impact of single pipe cross section on the safety of greenhouse skeleton has not been addressed so far. In this context, the finite element analysis software was used to calculate and analyze the stress elements, displacement of round tube, Ω tube, elliptic tube and square tube under the same load conditions. We used the Chinese Standard values as a reference and analyzed structural features of different sizes and thicknesses of the greenhouse steel skeleton sections under non-uniform snow load. The results showed that, under the same load condition, the maximum stress in the four skeleton materials was all located at the connection of the transverse tension bar and the front roof. In addition, under same load condition, the greenhouse skeleton with elliptic tube presented the smallest cross-sectional displacement between the different materials tested. The effect of increasing the size of the greenhouse frame was better than that of increasing the greenhouse material thickness. All this work will provide theoretical guidance to the material selection of this structure.
Identifiants
pubmed: 34588538
doi: 10.1038/s41598-021-98779-y
pii: 10.1038/s41598-021-98779-y
pmc: PMC8481531
doi:
Types de publication
Journal Article
Research Support, Non-U.S. Gov't
Langues
eng
Sous-ensembles de citation
IM
Pagination
19307Informations de copyright
© 2021. The Author(s).
Références
Li, T. Current situation and prospects of greenhouse industry development in China. J. Shenyang Agric. Univ. 36, 131–138 (2005).
Sun, J. et al. Development status and trends of protected horticulture in China. J. Nanjing Agric. Univ. 42, 594–604 (2019).
Wei, X., Zhou, C., Cao, N. & Ding, X. Design method for solar greenhouse outlines based on illumination conditions. North. Hortic. 15, 1–5 (2010).
Sun, Z., Huang, W. & Li, T. Light and temperature performance of energy-saving solar greenhouse assembled with color plate. Trans. Chin. Soc. Agric. Eng. 29, 159–167 (2013).
Chen, D., Zheng, H., Zhang, J. & Qiu, J. A comprehensive research on the metorological environment in sun-light greenhouse (III)—A comparative research on the total amount of direct radiation in the greenhouses with different arc lighting surfaces. Trans. Chin. Soc. Agric. Eng. 8, 78–82 (1992).
Bai, Y. & Ming, Y. Analysis of influence factor on safety and durability of steel skeleton of solar greenhouse. Room Mater. Appl. 33, 14–15 (2005).
Liu, J. & Zhou, C. The present and development of sunlight greenhouse structure optimization. J. Inn. Mong. Agric. Univ. 28, 264–268 (2007).
Briassoulis, D., Dougka, G., Dimakogianni, D. & Vayas, I. Analysis of the collapse of a greenhouse with vaulted roof. Biosyst. Eng. 151, 495–509 (2016).
doi: 10.1016/j.biosystemseng.2016.10.018
Guo, L. et al. A new steel structure solar greenhouse suitable for off-season cultivation of fruit trees. North. Hortic. 19, 45–48 (2019).
Xie, H. & Liu, Y. Investigation and analysis on performance of arch plastic greenhouse in Daqing. J. Heilongjiang Bayi Agric. Univ. 30, 85–91 (2018).
Zhang, Y. & Liang, J. The stress testing of solar greenhouse’s steel truss. J. Shenyang Agric. Univ. 33, 205–207 (2002).
Wang, W., Bai, Y., Huang, W., Liu, Y. & Wang, H. The analysis for the load testing of novel sliding energy-saving solar greenhouse’s steel truss. J. Shenyang Agric. Univ. 44, 683–686 (2013).
Wang, B., Jin, B. & Song, J. Finite element analysis of load bearing capacity of steel skeletons for solar greenhouses under vertical loads. J. Ningxia Univ. 30, 336–342 (2009).
Lu, Z. & Qiu, L. Finite element optimization of single slope solar greenhouse steel framework. Trans. Chin. Soc. Agric. Mach. 36, 150–154 (2005).
Bai, Y., Wang, H., Wang, T. & Li, T. Design and test of new steel frame solar greenhouse. J. Shenyang Agric. Univ. 44, 542–547 (2012).
Zhou, C. Dr. Zhou investigated the structure and structure of a single-tube skeleton solar greenhouse. Agric. Eng. Technol. 40, 49–54 (2020).
Iribarne, L., Torres, J. A. & Peña, A. Using computer modeling techniques to design tunnel greenhouse structures. Comput. Ind. 58, 403–415 (2007).
doi: 10.1016/j.compind.2006.09.001
Li, C., Liang, Z. & Ju, J. Spatial finite element analysis of heteromorphous greenhouse. J. China Agric. Univ. 12, 84–87 (2007).
Ren, J. et al. Finite element analysis of the static properties and stability of a large-span plastic greenhouse. Comput. Electron. Agric. 165, 104957 (2019).
doi: 10.1016/j.compag.2019.104957
Ha, T. et al. Finite element model updating of multi-span greenhouses based on ambient vibration measurements. Biosyst. Eng. 161, 145–156 (2017).
doi: 10.1016/j.biosystemseng.2017.06.019
Dai, C. et al. Analysis on snow distribution on sunlight greenhouse and its distribution coefficient. In International Federation for Information Processing, Vol. 452, 575–588 (2015).