Superconducting micro-resonators for electron spin resonance - the good, the bad, and the future.

EPR ESR Superconducting resonators

Journal

Journal of magnetic resonance (San Diego, Calif. : 1997)
ISSN: 1096-0856
Titre abrégé: J Magn Reson
Pays: United States
ID NLM: 9707935

Informations de publication

Date de publication:
Jan 2022
Historique:
received: 08 06 2021
revised: 17 08 2021
accepted: 30 10 2021
pubmed: 1 12 2021
medline: 1 12 2021
entrez: 30 11 2021
Statut: ppublish

Résumé

The field of electron spin resonance (ESR) is in constant need of improving its capabilities. Among other things, this means having better resonators to reach improved spin sensitivity and enable larger microwave-power-to-microwave-magnetic-field conversion factors. Surface micro-resonators, made of small metallic patches on a dielectric substrate, provide very good absolute spin sensitivity and high conversion factors due to their very small mode volume. However, such resonators suffer from relatively low spin concentration sensitivity and a low-quality factor, a fact that offsets some of their significant potential advantages. The use of superconducting patches to replace the metallic layer seems a reasonable and straightforward solution to the quality factor issue, at least for measurements carried out at cryogenic temperatures. Nevertheless, superconducting materials, especially those that can operate at moderate cryogenic temperatures, are not easily incorporated into setups requiring high magnetic fields due to the electric current vortices generated in the latter's surface. This makes the transition from normal conducting materials to superconductors highly nontrivial. Here we present the design, fabrication, and testing results of surface micro-resonators made of yttrium barium copper oxide (YBCO), a superconducting material that operates also at high magnetic fields and makes it possible to pursue ESR at moderate cryogenic temperatures (up to ∼ 80 K). We show that with a unique experimental setup, these resonators can be made to operate well even at high fields of ∼ 1.2 T. Furthermore, we analyze the effect of current vortices on the ESR signal and the spins' coherence times. Finally, we provide a head-to-head comparison of YBCO vs copper resonators of the same dimensions, which clearly shows their pros and cons and directs us to future potential developments and improvements in this field.

Identifiants

pubmed: 34847488
pii: S1090-7807(21)00191-9
doi: 10.1016/j.jmr.2021.107102
pii:
doi:

Types de publication

Journal Article

Langues

eng

Sous-ensembles de citation

IM

Pagination

107102

Informations de copyright

Copyright © 2021 Elsevier Inc. All rights reserved.

Déclaration de conflit d'intérêts

Declaration of Competing Interest The authors declare the following financial interests/personal relationships which may be considered as potential competing interests: Aharon Blank has some equity in a start-up company that developed the pulsed ESR spectrometer employed for the ESR measurements described in this paper.

Auteurs

Yaron Artzi (Y)

Schulich Faculty of Chemistry, Technion - Israel Institute of Technology, Haifa 3200003, Israel.

Yakir Yishay (Y)

Schulich Faculty of Chemistry, Technion - Israel Institute of Technology, Haifa 3200003, Israel.

Marco Fanciulli (M)

Department of Materials Science, University of Milano - Bicocca, Italy.

Moamen Jbara (M)

Schulich Faculty of Chemistry, Technion - Israel Institute of Technology, Haifa 3200003, Israel.

Aharon Blank (A)

Schulich Faculty of Chemistry, Technion - Israel Institute of Technology, Haifa 3200003, Israel. Electronic address: ab359@technion.ac.il.

Classifications MeSH