Wide-Band Interference Mitigation in GNSS Receivers Using Sub-Band Automatic Gain Control.

The performance of global navigation satellite system (GNSS) receivers is significantly affected by interference signals. For this reason, several research groups have proposed methods to mitigate the effect of different kinds of jammers. One effective method for wide-band interference mitigation (IM) is the high-rate DFT-based data manipulator (HDDM) pulse blanker (PB). It provides good performance to pulsed and frequency sparse interference. However, it and many other methods have poor performance against wide-band noise signals, which are not frequency-sparse. This article proposes to include automatic gain control (AGC) in the HDDM structure to attenuate the signal instead of removing it: the HDDM-AGC. It overcomes the wide-band noise limitation for IM at the cost of limiting mitigation capability to other signals. Previous studies with this approach were limited to only measuring the carrier-to-noise density ratio (C/N0) performance of tracking, but this article extends the analysis to include the impact of the HDDM-AGC algorithm on the position, velocity, and time (PVT) solution. It allows an end-to-end evaluation and impact assessment of mitigation to a GNSS receiver. This study compares two commercial receivers: one high-end and one low-cost, with and without HDDM IM against laboratory-generated interference signals. The results show that the HDDM-AGC provides a PVT availability and precision comparable to high-end commercial receivers with integrated mitigation for most interference types. For pulse interferences, its performance is superior. Further, it is shown that degradation is minimized against wide-band noise interferences. Regarding low-cost receivers, the PVT availability can be increased up to 40% by applying an external HDDM-AGC.