Biodegradable open-porous scaffolds made of sintered magnesium W4 and WZ21 short fibres show biocompatibility in vitro and in long-term in vivo evaluation.

Biodegradable metal Bone defects Magnesium alloy Open-porous Scaffold Temporary implant

Journal

Acta biomaterialia
ISSN: 1878-7568
Titre abrégé: Acta Biomater
Pays: England
ID NLM: 101233144

Informations de publication

Date de publication:
08 2022
Historique:
received: 12 02 2022
revised: 27 05 2022
accepted: 01 06 2022
pubmed: 13 6 2022
medline: 27 7 2022
entrez: 12 6 2022
Statut: ppublish

Résumé

Open-porous scaffolds made of W4 and WZ21 fibres were evaluated to analyse their potential as an implant material. WZ21 scaffolds without any surface modification or coating, showed promising mechanical properties which were comparable to the W4 scaffolds tested in previous studies. Eudiometric testing results were dependent on the experimental setup, with corrosion rates differing by a factor of 3. Cytotoxicity testing of WZ21 showed sufficient cytocompatibility. The corrosion behavior of the WZ21 scaffolds in different cell culture media are indicating a selective dealloying of elements from the magnesium scaffold by different solutions. Long term in-vivo studies were using 24 W4 scaffolds and 12 WZ21 scaffolds, both implanted in rabbit femoral condyles. The condyles and important inner organs were explanted after 6, 12 and 24 weeks and analyzed. The in-vivo corrosion rate of the WZ21 scaffolds calculated by microCT-based volume loss was up to 49 times slower than the in-vitro corrosion rate based on weight loss. Intramembranous bone formation within the scaffolds of both alloys was revealed, however a low corrosion rate and formation of gas cavities at initial time points were also detected. No systemic or local toxicity could be observed. Investigations by μ-XRF did not reveal accumulation of yttrium in the neighboring tissue. In summary, the magnesium scaffold´s performance is biocompatible, but would benefit from a surface modification, such as a coating to obtain lower the initial corrosion rates, and hereby establish a promising open-porous implant material for load-bearing applications. STATEMENT OF SIGNIFICANCE: Magnesium is an ideal temporary implant material for non-load bearing applications like bigger bone defects, since it degrades in the body over time. Here we developed and tested in vitro and in a rabbit model in vivo degradable open porous scaffolds made of sintered magnesium W4 and WZ21 short fibres. These scaffolds allow the ingrowth of cells and blood vessels to promote bone healing and regeneration. Both fibre types showed in vitro sufficient cytocompatibility and proliferation rates and in vivo, no systemic toxicity could be detected. At the implantation site, intramembranous bone formation accompanied by ingrowth of supplying blood vessels within the scaffolds of both alloys could be detected.

Identifiants

pubmed: 35691561
pii: S1742-7061(22)00343-9
doi: 10.1016/j.actbio.2022.06.005
pii:
doi:

Substances chimiques

Alloys 0
Magnesium I38ZP9992A

Types de publication

Journal Article Research Support, Non-U.S. Gov't

Langues

eng

Sous-ensembles de citation

IM

Pagination

389-404

Informations de copyright

Copyright © 2022 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

Déclaration de conflit d'intérêts

Declaration of Competing Interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper.

Auteurs

Katharina Bobe (K)

Laboratory for Biomechanics and Biomaterials, Department of Orthopaedic Surgery, Hannover Medical School, Anna-von-Borries-Straße 1-7, Hannover 30625, Germany.

Elmar Willbold (E)

Laboratory for Biomechanics and Biomaterials, Department of Orthopaedic Surgery, Hannover Medical School, Anna-von-Borries-Straße 1-7, Hannover 30625, Germany. Electronic address: willbold.elmar@mh-hannover.de.

Maike Haupt (M)

Laboratory for Biomechanics and Biomaterials, Department of Orthopaedic Surgery, Hannover Medical School, Anna-von-Borries-Straße 1-7, Hannover 30625, Germany.

Mattias Reebmann (M)

Laboratory for Biomechanics and Biomaterials, Department of Orthopaedic Surgery, Hannover Medical School, Anna-von-Borries-Straße 1-7, Hannover 30625, Germany.

Ingrid Morgenthal (I)

Fraunhofer Institute for Manufacturing Technology and Advanced Materials IFAM, Branch Lab Dresden, Winterbergstraße 28, Dresden 01277, Germany.

Olaf Andersen (O)

Fraunhofer Institute for Manufacturing Technology and Advanced Materials IFAM, Branch Lab Dresden, Winterbergstraße 28, Dresden 01277, Germany.

Thomas Studnitzky (T)

Fraunhofer Institute for Manufacturing Technology and Advanced Materials IFAM, Branch Lab Dresden, Winterbergstraße 28, Dresden 01277, Germany.

Jens Nellesen (J)

Institute of Materials Engineering, Technische Universität Dortmund, Leonhard-Euler-Straße 2, Dortmund 44227, Germany.

Wolfgang Tillmann (W)

Institute of Materials Engineering, Technische Universität Dortmund, Leonhard-Euler-Straße 2, Dortmund 44227, Germany.

Carla Vogt (C)

Institute for Analytical Chemistry, University of Mining and Technology, Leipziger Straße 29, Freiberg 09599, Germany.

Kelim Vano-Herrera (K)

Deutsches Institut für Kautschuktechnologie, Eupener Straße 33, Hannover 30519, Germany.

Frank Witte (F)

Department of Prosthodontics, Geriatric Dentistry and Craniomandibular Disorders, Dental Materials and Biomaterial Research, Charité - Universitätsmedizin Berlin, Corporate Member of Freie Universität Berlin and Humboldt-Universität zu Berlin, Aßmannshauser Straße 4-6, Berlin 14197, Germany.

Articles similaires

Robotic Surgical Procedures Animals Humans Telemedicine Models, Animal

Odour generalisation and detection dog training.

Lyn Caldicott, Thomas W Pike, Helen E Zulch et al.
1.00
Animals Odorants Dogs Generalization, Psychological Smell
Animals TOR Serine-Threonine Kinases Colorectal Neoplasms Colitis Mice
Animals Tail Swine Behavior, Animal Animal Husbandry

Classifications MeSH