Load-induced fluid pressurisation in hydrogel systems before and after reinforcement by melt-electrowritten fibrous meshes.

Agarose Alginate Fluid load support Gelatin methacryloyl Micro-indentation Poroelasticity Reinforced scaffolds Unconfined compression Viscoelasticity

Journal

Journal of the mechanical behavior of biomedical materials
ISSN: 1878-0180
Titre abrégé: J Mech Behav Biomed Mater
Pays: Netherlands
ID NLM: 101322406

Informations de publication

Date de publication:
07 2023
Historique:
received: 16 02 2023
revised: 25 05 2023
accepted: 28 05 2023
medline: 12 6 2023
pubmed: 8 6 2023
entrez: 7 6 2023
Statut: ppublish

Résumé

Fluid pressure develops transiently within mechanically-loaded, cell-embedding hydrogels, but its magnitude depends on the intrinsic material properties of the hydrogel and cannot be easily altered. The recently developed melt-electrowriting (MEW) technique enables three-dimensional printing of structured fibrous mesh with small fibre diameter (20 μm). The MEW mesh with 20 μm fibre diameter can synergistically increase the instantaneous mechanical stiffness of soft hydrogels. However, the reinforcing mechanism of the MEW meshes is not well understood, and may involve load-induced fluid pressurisation. Here, we examined the reinforcing effect of MEW meshes in three hydrogels: gelatin methacryloyl (GelMA), agarose and alginate, and the role of load-induced fluid pressurisation in the MEW reinforcement. We tested the hydrogels with and without MEW mesh (i.e., hydrogel alone, and MEW-hydrogel composite) using micro-indentation and unconfined compression, and analysed the mechanical data using biphasic Hertz and mixture models. We found that the MEW mesh altered the tension-to-compression modulus ratio differently for hydrogels that are cross-linked differently, which led to a variable change to their load-induced fluid pressurisation. MEW meshes only enhanced the fluid pressurisation for GelMA, but not for agarose or alginate. We speculate that only covalently cross-linked hydrogels (GelMA) can effectively tense the MEW meshes, thereby enhancing the fluid pressure developed during compressive loading. In conclusion, load-induced fluid pressurisation in selected hydrogels was enhanced by MEW fibrous mesh, and may be controlled by MEW mesh of different designs in the future, thereby making fluid pressure a tunable cell growth stimulus for tissue engineering involving mechanical stimulation.

Identifiants

pubmed: 37285774
pii: S1751-6161(23)00294-1
doi: 10.1016/j.jmbbm.2023.105941
pii:
doi:

Substances chimiques

Hydrogels 0
Sepharose 9012-36-6
Gelatin 9000-70-8
Alginates 0

Types de publication

Journal Article Research Support, Non-U.S. Gov't

Langues

eng

Sous-ensembles de citation

IM

Pagination

105941

Informations de copyright

Copyright © 2023 Elsevier Ltd. All rights reserved.

Déclaration de conflit d'intérêts

Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper.

Auteurs

Eng Kuan Moo (EK)

Department of Technical Physics, University of Eastern Finland, Finland; Department of Mechanical and Aerospace Engineering, Carleton University, Canada; Human Performance Laboratory, Faculty of Kinesiology, University of Calgary, Canada. Electronic address: EngKuanMoo@cunet.carleton.ca.

Mohammadhossein Ebrahimi (M)

Department of Technical Physics, University of Eastern Finland, Finland. Electronic address: mohammadhossein.ebrahimi@uef.fi.

Andrei Hrynevich (A)

Department of Orthopaedics, University Medical Center Utrecht, the Netherlands. Electronic address: a.hrynevich@umcutrecht.nl.

Mylène de Ruijter (M)

Department of Orthopaedics, University Medical Center Utrecht, the Netherlands. Electronic address: m.deruijter@umcutrecht.nl.

Miguel Castilho (M)

Department of Orthopaedics, University Medical Center Utrecht, the Netherlands; Department of Biomedical Engineering, Eindhoven University of Technology, the Netherlands. Electronic address: m.dias.castilho@tue.nl.

Jos Malda (J)

Department of Orthopaedics, University Medical Center Utrecht, the Netherlands; Department of Clinical Sciences, Faculty of Veterinary Medicine, Utrecht University, the Netherlands. Electronic address: j.malda@umcutrecht.nl.

Rami K Korhonen (RK)

Department of Technical Physics, University of Eastern Finland, Finland. Electronic address: rami.korhonen@uef.fi.

Articles similaires

Organoids Humans Tissue Engineering Coculture Techniques Regenerative Medicine
Animals Osteogenesis Osteoporosis Mesenchymal Stem Cells Humans
Organoids Animals Kidney Mice Humans

Classifications MeSH