Correlation Between Sagittal Balance and Mechanical Distal Junctional Failure in Degenerative Pathology of the Spine: A Retrospective Analysis.

lumbar distal junctional pathology mechanism of failure retrospective clinical study sagittal balance spinal fixation failure spinopelvic parameters

Journal

Global spine journal
ISSN: 2192-5682
Titre abrégé: Global Spine J
Pays: England
ID NLM: 101596156

Informations de publication

Date de publication:
10 Aug 2023
Historique:
pubmed: 11 8 2023
medline: 11 8 2023
entrez: 10 8 2023
Statut: aheadofprint

Résumé

Retrospective cohort study. This study aimed to investigate the failure of the caudal end of lumbar posterior fixation in terms of pre-operative and post-operative spinopelvic parameters, correction performed, demographic and clinical data. The lumbar, thoraco-lumbar and lumbo-sacral posterior fixations performed with pedicle screws and rods in 2017-2019 were retrospectively analyzed. As 81% failures occurred within 4 years, an observational period of 4 years was chosen. The revision surgeries due to the failure in the caudal end were collected in the junctional group. Fixations which have not failed were gathered in the control group. The main spinopelvic parameters were measured for each patient on standing lateral radiographs with the software Surgimap. Demographic and clinical data were extracted for both groups. Among the 457 patients who met the inclusion criteria, the junctional group included 101 patients, who required a revision surgery. The control group collected 356 primary fixations. The two most common causes of revision surgeries were screws pullout (57 cases) and rod breakage (53 cases). SVA, PT, LL, PI-LL and TPA differed significantly between the two groups ( Mechanical failure is more likely to occur in patients older than 40 years with a thoraco-lumbar fixation where PT, PI-LL and TPA were not properly restored.

Identifiants

pubmed: 37562976
doi: 10.1177/21925682231195954
doi:

Types de publication

Journal Article

Langues

eng

Pagination

21925682231195954

Auteurs

Sara Montanari (S)

Department of Industrial Engineering, School of Engineering and Architecture, Alma Mater Studiorum - Università di Bologna, Bologna, Italy.

Cristiana Griffoni (C)

Spine Surgery Department, IRCCS Rizzoli Orthopaedic Institute, Bologna, Italy.

Luca Cristofolini (L)

Department of Industrial Engineering, School of Engineering and Architecture, Alma Mater Studiorum - Università di Bologna, Bologna, Italy.

Marco Girolami (M)

Spine Surgery Department, IRCCS Rizzoli Orthopaedic Institute, Bologna, Italy.

Alessandro Gasbarrini (A)

Spine Surgery Department, IRCCS Rizzoli Orthopaedic Institute, Bologna, Italy.

Giovanni Barbanti Bròdano (G)

Spine Surgery Department, IRCCS Rizzoli Orthopaedic Institute, Bologna, Italy.

Classifications MeSH