Impact of Calcium-Hydroxide, Sodium Ascorbate, and Sodium Thiosulphate on Bond Strength of Composite Restorations to Bleached Dentin.

This study evaluated the impact of using calcium-hydroxide or the antioxidant agents on the bond strength of adhesive restorations to bleached dentin. Forty teeth were prepared and allocated into 8 groups according to the surface treatment after bleaching (application or not of calcium hydroxide, 10% sodium ascorbate and 5% sodium thiosulphate for 10min), and the time of final restoration (immediate or after 7-days). Sodium perborate with 20% hydrogen peroxide was applied for 3 weeks using a developed artificial pulp chamber, with replacement every week. Composite resin restoration was performed and microtensile test was performed. Then, specimens were analyzed using a stereomicroscope and SEM. Data was submitted to Kruskal-Wallis and Dunn tests (p<0.05). The bond strength of non-bleached teeth was similar to the groups restored after 7 days of bleaching (p<0.05). The lowest values of bond strength were showed by groups restored immediately after bleaching (p<0.05). In all groups, there was a considerable predominance of adhesive fractures. Delaying the final restoration of teeth submitted to nonvital bleaching for 7 days permits an increase in bond strength. The immediate restoration of bleached teeth after the use of 10% sodium ascorbate or 5% sodium thiosulfate for 10 minutes showed unsatisfactory results. Clinical relevance Irrespective of the dentin protocol applied before adhesion, a satisfactory and an unsatisfactory result of bond strength values will be obtained delaying the final restoration or immediately performing the final restoration, respectively. Therefore, after nonvital tooth bleaching, clinicians should always delay the final restoration for a minimum period of 7 days.