Experimental characterization of residual deformations in human descending thoracic aortas.

Descending thoracic aortas Experiments Human aorta Residual strains Residual stress

Journal

Journal of the mechanical behavior of biomedical materials
ISSN: 1878-0180
Titre abrégé: J Mech Behav Biomed Mater
Pays: Netherlands
ID NLM: 101322406

Informations de publication

Date de publication:
02 Mar 2024
Historique:
received: 30 01 2024
revised: 18 02 2024
accepted: 01 03 2024
medline: 14 3 2024
pubmed: 14 3 2024
entrez: 13 3 2024
Statut: aheadofprint

Résumé

The effect of residual stresses on the deformation of human aortas under pulsatile pressure is relevant. Experimental measurements of residual deformations are necessary to characterize residual stresses in human aortas. For this reason, an experimental study is carried out. In the present study, longitudinal and circumferential strips from descending thoracic aortas obtained from 21 donors, harvested during organ donation explant, underwent residual deformation measurements. The intact wall and the three separated layers were tested in both directions, resulting in 8 tests per donor, which gives a relevant set of experimental data for further studies. Results show significant residual deformations both in circumferential and longitudinal directions, which are compatible with a significantly compressed intima in the unloaded aorta. In particular, the measured mean effective curvature was -0.193 ± 0.064 (1/mm) for the circumferential strips and -0.076 ± 0.030 (1/mm) for longitudinal strips of the full wall. The effects of age and gender were also investigated.

Identifiants

pubmed: 38479211
pii: S1751-6161(24)00124-3
doi: 10.1016/j.jmbbm.2024.106492
pii:
doi:

Types de publication

Journal Article

Langues

eng

Sous-ensembles de citation

IM

Pagination

106492

Informations de copyright

Copyright © 2024 Elsevier Ltd. All rights reserved.

Déclaration de conflit d'intérêts

Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper.

Auteurs

Marco Amabili (M)

School of Engineering, Westlake University, Hangzhou, Zhejiang province, PR China; Department of Mechanical Engineering, McGill University, Montreal, Canada. Electronic address: marco.amabili@mcgill.ca.

Giulio Franchini (G)

Advanced Material Research Center, Technology Innovation Institute, Abu Dhabi, United Arab Emirates.

Rinaldo Garziera (R)

Dipartimento di Ingegneria ed Architettura, University of Parma, Parma, Italy.

Classifications MeSH