Development towards a novel screening method for nipecotic acid bioisosteres using molecular imprinted polymers (MIPs) as alternative to in vitro cellular uptake assays.

Bioisostere In vitro screening Molecular imprinted polymer Nipecotic acid

Journal

Talanta
ISSN: 1873-3573
Titre abrégé: Talanta
Pays: Netherlands
ID NLM: 2984816R

Informations de publication

Date de publication:
10 Jul 2024
Historique:
received: 25 01 2024
revised: 12 06 2024
accepted: 29 06 2024
medline: 12 7 2024
pubmed: 12 7 2024
entrez: 11 7 2024
Statut: aheadofprint

Résumé

Impaired expression of GABA transporters (GATs) is closely related to the pathogenesis of among others Parkinson's disease and epilepsy. As such, lipophilic nipecotic acid analogs have been extensively studied as GAT1-addressing drugs and radioligands but suffer from limited brain uptake due to the zwitterionic properties of the nipecotic acid moiety. Bioisosteric replacement of the carboxylic acid group is a promising strategy to improve the brain uptake, though it requires knowledge on the binding of these isosteres to GAT1. To screen nipecotic acid isosteres for their affinity to GAT1 in a time- and cost-effective manner, this research aims to develop a molecular imprinted polymer (MIP) that mimics the natural binding site of GAT1 and can act as an alternative screening tool to the current radiometric and mass spectrometry cellular-based assays. To this end, a nipecotic acid MIP was created using the electropolymerization of ortho-phenylenediamine (oPD) by cyclic voltammetry (CV). The optimization of the generated receptor layer was achieved by varying the scan rate (50-250 mV/s) and number of CV cycles (5-12), yielding an optimized MIP with an average imprinting factor of 2.6, a linear range of 1-1000 nm, and a theoretical LOD of 0.05 nm, as analyzed by electrical impedance spectroscopy (EIS). Selectivity studies facilitated the investigation of major binding interactions between the MIP and the substrate, building an experimental model that compares characteristics of various analogs. Results from this model indicate that the substrate carboxylic acid group plays a more important role in binding than an amine group, after comparing the binding of cyclohexanecarboxylic acid (average IF of 1.7) and piperidine (average IF of 0.46). The research culminates in a discussion regarding the feasibility of the in vitro model, comparing the synthetic system against the biological performance of GAT1. Thus, evaluating if it is possible to generate a synthetic GAT1 mimic, and if so, provide directions for follow-up research.

Identifiants

pubmed: 38991407
pii: S0039-9140(24)00879-8
doi: 10.1016/j.talanta.2024.126500
pii:
doi:

Types de publication

Journal Article

Langues

eng

Sous-ensembles de citation

IM

Pagination

126500

Informations de copyright

Copyright © 2024 The Authors. Published by Elsevier B.V. All rights reserved.

Déclaration de conflit d'intérêts

Declaration of competing interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper.

Auteurs

Niels Knippenberg (N)

Sensor Engineering Department, Faculty of Science and Engineering, Maastricht University, 6200 MD, Maastricht, the Netherlands. Electronic address: niels.knippenberg@maastrichtuniversity.nl.

Joseph W Lowdon (JW)

Sensor Engineering Department, Faculty of Science and Engineering, Maastricht University, 6200 MD, Maastricht, the Netherlands.

Margaux Frigoli (M)

Sensor Engineering Department, Faculty of Science and Engineering, Maastricht University, 6200 MD, Maastricht, the Netherlands.

Thomas J Cleij (TJ)

Sensor Engineering Department, Faculty of Science and Engineering, Maastricht University, 6200 MD, Maastricht, the Netherlands.

Kasper Eersels (K)

Sensor Engineering Department, Faculty of Science and Engineering, Maastricht University, 6200 MD, Maastricht, the Netherlands.

Bart van Grinsven (B)

Sensor Engineering Department, Faculty of Science and Engineering, Maastricht University, 6200 MD, Maastricht, the Netherlands.

Hanne Diliën (H)

Sensor Engineering Department, Faculty of Science and Engineering, Maastricht University, 6200 MD, Maastricht, the Netherlands.

Classifications MeSH