Fabricating a Low-Cost, Microscopy-Compatible Mechanical Testing Device.

Most commercially-available mechanical testing devices are bulky, expensive, and unable to evaluate changes in sample microstructure under load. This leaves a crucial gap in understanding between material structure and bulk mechanical properties. Our objective was to fabricate a mechanical testing device small enough to fit in most upright or inverted microscopy stages and able to position samples to allow for simultaneous mechanical and microstructural characterization. Parts were 3D printed using the hobbyist-friendly Fused Filament Fabrication technique, then assembled with commercial fasteners and translation components to create a mechanical testing device that utilized the deflection of plastic posts to determine sample reaction forces under applied strain. Video of sample deformation was analyzed using a custom processing script to calculate stress and strain behavior in an automated and high-throughput manner. This device was able to perform mechanical characterization with an accuracy comparable to commercial mechanical testing devices for a wide range of nonlinear and viscoelastic samples under dry and hydrated conditions. Additionally, the device showed compatibility with different upright and inverted microscopes and was able to demonstrate accurate mechanical testing results when used with these instruments. We successfully developed a device capable of accurately testing a majority of soft materials in the field of Biomedical Engineering with the ability to perform additional microstructural characterization using microscopy at a price point of $600.

Déclaration de conflit d'intérêts

6.2Conflicts of Interest/Competing Interests On behalf of all authors, the corresponding author states that there is no conflict of interest.