Indentation of living cells by AFM tips may not be what we thought!

AFM Hertz model Indentation Young's modulus

Journal

Micron (Oxford, England : 1993)
ISSN: 1878-4291
Titre abrégé: Micron
Pays: England
ID NLM: 9312850

Informations de publication

Date de publication:
11 2023
Historique:
received: 19 06 2023
revised: 08 08 2023
accepted: 08 08 2023
medline: 18 9 2023
pubmed: 19 8 2023
entrez: 18 8 2023
Statut: ppublish

Résumé

The models used to calculate Young's moduli from atomic force microscopy (AFM) force curves consider the shape of the indentation. It is then assumed that the geometry of the indentation is identical to the geometry of the indenter, which has been verified for hard materials (E > 1 MPa). Based on this assumption, the force curves calculated by these models, for the same object with a given Young's modulus, are different if the indenter geometry is different. On the contrary, we observe experimentally that the force curves recorded on soft living cells, with pyramidal, spherical, or tipless indenters, are almost similar. This indicates that this basic assumption on the indentation geometry does not work for soft materials (E of the order of 5 kPa or less). This means that, in this case, the shape of the indentation is therefore different from the shape of the indenter. Indentation of living cells by AFM is not what we thought!

Identifiants

pubmed: 37595406
pii: S0968-4328(23)00121-X
doi: 10.1016/j.micron.2023.103523
pii:
doi:

Types de publication

Journal Article Research Support, Non-U.S. Gov't

Langues

eng

Sous-ensembles de citation

IM

Pagination

103523

Informations de copyright

Copyright © 2023 Elsevier Ltd. All rights reserved.

Déclaration de conflit d'intérêts

Declaration of Competing Interest The authors declare the following financial interests/personal relationships which may be considered as potential competing interests: Etienne DAGUE reports financial support was provided by French National Research Agency.

Auteurs

Ophélie Thomas-Chemin (O)

LAAS-CNRS, Université de Toulouse, CNRS, Toulouse, France.

Childérick Séverac (C)

RESTORE Research Center, Université de Toulouse, INSERM, CNRS, EFS, ENVT, Université P. Sabatier, Toulouse, France.

Emmanuelle Trévisiol (E)

TBI, Université de Toulouse, CNRS, INRAE, INSA, Toulouse, France.

Etienne Dague (E)

LAAS-CNRS, Université de Toulouse, CNRS, Toulouse, France. Electronic address: edague@laas.fr.

Articles similaires

Silicon Dioxide Water Hot Temperature Compressive Strength X-Ray Diffraction

Characterization of 3D printed composite for final dental restorations.

Lucas Eigi Borges Tanaka, Camila da Silva Rodrigues, Manassés Tércio Vieira Grangeiro et al.
1.00
Composite Resins Materials Testing Printing, Three-Dimensional Surface Properties Flexural Strength
Molecular Dynamics Simulation Printing, Three-Dimensional Polymethyl Methacrylate Temperature Dental Materials
1.00
Calcium Carbonate Peptoids Carbon Dioxide Crystallization Microscopy, Atomic Force

Classifications MeSH