Simultaneous phosphorus precipitation and sludge thickening by electrolysis with an anode covered by bivalve shells.

A wastewater treatment plant with a large inflow of phosphorus (P) is a potential P source that can act as an alternative to phosphate rocks and a renewable source of P. During electrolysis with inert electrodes, hydroxide ions generated from the cathode cause calcium phosphate (CaP) precipitation, and oxygen and hydrogen generated from the electrodes cause thickening of the sludge by electroflotation in sludge treatment streams. However, these two effects have not been achieved simultaneously because the precipitation of CaP requires much more time than that required for thickening by electroflotation. In this study, an electrolysis system that used an anode covered with bivalve shells was used. Batch experiments were conducted and the results demonstrated that covering the anode with shells resulted in their dissolution and that the calcium ions provided by this process considerably enhanced P removal in the form of CaP, thereby shortening the time required for CaP precipitation. In continuous experiments with excess sludge, electrolysis with shells accomplished sludge thickening by electroflotation (the thickened sludge had 5.5 times the total solids in the original excess sludge) and low relative phosphate-P concentrations (0.0545-0.0812) in the effluent compared to the influent. This effect is attributed to CaP precipitation. Additional mixing of the CaP precipitates in the effluent enhanced their settleability. The results demonstrate that electrolysis using an anode covered with bivalve shells simultaneously achieved CaP precipitation and sludge thickening.

Informations de copyright

Copyright © 2023 Elsevier Ltd. All rights reserved.

Déclaration de conflit d'intérêts

Declaration of Competing Interest The authors declare that they have no conflict of interest.