Development of long-acting injectable suspensions by continuous antisolvent crystallization: An integrated bottom-up process.


Journal

International journal of pharmaceutics
ISSN: 1873-3476
Titre abrégé: Int J Pharm
Pays: Netherlands
ID NLM: 7804127

Informations de publication

Date de publication:
15 Dec 2023
Historique:
received: 18 05 2023
revised: 27 08 2023
accepted: 23 10 2023
medline: 5 12 2023
pubmed: 28 10 2023
entrez: 27 10 2023
Statut: ppublish

Résumé

Our present work elucidated the operational feasibility of direct generation and stabilization of long-acting injectable (LAI) suspensions of a practically insoluble drug, itraconazole (ITZ), by combining continuous liquid antisolvent crystallization with downstream processing (i.e., centrifugal filtration and reconstitution). A novel microchannel reactor-based bottom-up crystallization setup was assembled and optimized for the continuous production of micro-suspension. Based upon the solvent screening and solubility study, N-methyl pyrrolidone (NMP) was selected as the optimal solvent and an impinging jet Y-shaped microchannel reactor (MCR) was selected as the fluidic device to provide a reproducible homogenous mixing environment. Operating parameters such as solvent to antisolvent ratio (S/AS), total jet liquid flow rates (TFRs), ITZ feed solution concentration and the maturation time in spiral tubing were tailored to 1:9 v/v, 50 mL/min, 10 g/100 g solution, and 96 h, respectively. Vitamin E TPGS (0.5% w/w) was found to be the most suitable excipient to stabilize ITZ particles amongst 14 commonly used stabilizers screened. The effect of scaling up from 25 mL to 15 L was evaluated effectively with in situ monitoring of particle size distribution (PSD) and solid-state form. Thereafter, the suspension was subjected to centrifugal filtration to remove excess solvent and increase ITZ solid fraction. As an alternative, an even more concentrated wet pellet was reconstituted with an aqueous solution of 0.5% w/w Vitamin E TPGS as resuspending agent. The ITZ LAI suspension (of 300 mg/mL solid concentration) has the optimal PSD with a D10 of 1.1 ± 0.3 µm, a D50 of 3.53 ± 0.4 µm and a D90 of 6.5 ± 0.8 µm, corroborated by scanning electron microscopy (SEM), as remained stable after 548 days of storage at 25 °C. Finally, in vitro release methods using Dialyzer, dialysis membrane sac were investigated for evaluation of dissolution of ITZ LAI suspensions. The framework presented in this manuscript provides a useful guidance for development of LAI suspensions by an integrated bottom-up approach using ITZ as model API.

Identifiants

pubmed: 37890647
pii: S0378-5173(23)00971-7
doi: 10.1016/j.ijpharm.2023.123550
pii:
doi:

Substances chimiques

Itraconazole 304NUG5GF4
Solvents 0
Vitamin E 1406-18-4
Suspensions 0

Types de publication

Journal Article

Langues

eng

Sous-ensembles de citation

IM

Pagination

123550

Informations de copyright

Copyright © 2023. Published by Elsevier B.V.

Déclaration de conflit d'intérêts

Declaration of Competing Interest The authors declare that they have no known competing financial interests or personal relationships that could have appeared to influence the work reported in this paper.

Auteurs

Snehashis Nandi (S)

Chemical and Pharmaceutical Development & Supply, Janssen Research & Development, Beerse, Belgium; Department of Chemical Sciences, Bernal Institute, University of Limerick, Limerick V94 T9PX, Ireland; SSPC, The SFI Research Centre for Pharmaceuticals, Department of Chemical Sciences, Bernal Institute, University of Limerick, Ireland.

Luis Padrela (L)

Department of Chemical Sciences, Bernal Institute, University of Limerick, Limerick V94 T9PX, Ireland; SSPC, The SFI Research Centre for Pharmaceuticals, Department of Chemical Sciences, Bernal Institute, University of Limerick, Ireland.

Lidia Tajber (L)

SSPC, The SFI Research Centre for Pharmaceuticals, Department of Chemical Sciences, Bernal Institute, University of Limerick, Ireland; School of Pharmacy and Pharmaceutical Sciences, Trinity College Dublin, College Green, Dublin 2, Ireland.

Alain Collas (A)

Chemical and Pharmaceutical Development & Supply, Janssen Research & Development, Beerse, Belgium. Electronic address: ACOLLAS@its.jnj.com.

Articles similaires

Inclusion Bodies Solubility Recombinant Proteins Detergents Protein Denaturation
Nanoparticles Needles Polylactic Acid-Polyglycolic Acid Copolymer Polyethylene Glycols Curcumin

Elucidating ATP's role as solubilizer of biomolecular aggregate.

Susmita Sarkar, Saurabh Gupta, Chiranjit Mahato et al.
1.00
Adenosine Triphosphate Protein Aggregates Solubility Humans Protein Conformation

Comparative assessment of physics-based in silico methods to calculate relative solubilities.

Adiran Garaizar Suarez, Andreas H Göller, Michael E Beck et al.
1.00
Solvents Solubility Quantum Theory Molecular Dynamics Simulation Thermodynamics

Classifications MeSH